Epoxy.com Product #315BC High-Build Polymeric Coating is a two component, 100% solids polymeric Hi-Build polymeric coating used for high foot and light forklift traffic areas where abrasion resistance is required; for protection against mild corrosion; and as a decorative waterproof coating for walls, floors, tanks, pools etc. Also used as a base coat for Epoxy.com Chip Flooring System.
Surface to receive Epoxy.com Product #315BC High-Build Polymeric Coating must be clean and sound. Remove all dirt, laitance, grease curing compounds and other foreign matter by sandblasting, or mechanical abrasion. Remove water and dust from all surfaces with an oil free blast immediately prior to application.
Temperature of Epoxy.com Product #315BC High-Build Polymeric Coating (normal cure) must be 50° F or above at time of mixing. Stir each component separately before blending. Mix two parts by volume of Part A with one part by volume of Part B for three minutes with a low speed electric drill motor equipped with a mixing paddle.
ApplyEpoxy.com Product #315BC High-Build Polymeric Coating with a roller, brush, or spray equipment. When not used as part of the 315 Chip Flooring System, 2 coats are recommended. Thickness per coat should be 7-10 mils. Seven days cure time is required to reach maximum chemical resistance. When installing over concrete Product #899 or Product #203 Primer is recommended.
DO NOT apply Epoxy.com Product #315BC High-Build Polymeric Coating at temperatures below 50° F. Surface must be dry.
Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.
All tools and equipment should be cleaned before the system gels. Use MEK, Acetone, or any lacquer solvent
APPLICATION PROPERTIES @77°F |
||
| Mix Ratio | 2:1 By Volume | |
| Viscosity (mixed) | 950 CPS | |
| Pot Life (200 gr.) in minutes @70° F. | 30-40(normal cure) | |
| Set Time in Hours @ 70° F. | 10-12 (normal cure) | |
| Initial Cure | 24 Hours | |
| Final Cure | 5 Days | |
| Packaging Unit Size | 3 gallon units (2 gallons of "A" + 1 gallon of "B" | |
| Standard Colors | White, Light Gray, Dark Gray, Taupe, Sand, Old Gold, Mocha, Brick Red, Slate Blue, Colonial Green, Deep Blue, Black, Safety Yellow |
|
Click the picture
of color card below for a larger version of this picture
of the color chart.Epoxy.com a division of Epoxy Systems, Inc. certifies that Epoxy.com meet or exceed LEED requirements as summarized below:
Indoor Environmental Quality/Air Quality Before Occupancy Materials meet the requirement for VOC content Pertaining to LEED IEQ 4.2 Indoor Emitting Materials Credit. Refer to the individual product component technical data sheets and MSDS for further information.