Epoxy Gel Super Fast Cure Product #2704 is a fast setting, 100% solids epoxy crack gel and filler used to line, patch, or repair floor and wall surfaces. Epoxy Gel Super Fast Cure Product #2704 is the ideal material for repair of surfaces damaged from environmental or chemical attack. Epoxy Gel Super Fast Cure Product #2704 can also be used as a base material beneath coating, slurry, and mortar systems to repair before coating.
100% Solids Epoxy Resin with Aliphatic Amines
Surface Preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Epoxy.com Surface Preparation Procedures. The Epoxy.com technical service department is available to answer any questions.
Epoxy Gel Super Fast Cure Product #2704 is mixed by combining equal parts by volume of Part A and Part B. Mix until a consistent color is reached. Small amounts of Epoxy Gel Super Fast Cure Product #2704 can be mixed on a mortar board using a spatula. Epoxy Gel Super Fast Cure Product #2704 is installed using a trowel, spatula, or knife. For complete installation instructions, contact Epoxy.com Technical Support.
Clean skin with soap and water. Tools and equipment should be cleaned with xylene or lacquer thinner before Epoxy Gel Super Fast Cure Product #2704 gels.
Coverage of Epoxy Gel Super Fast Cure Product #2704 varies with application. One gallon contains approximately 231 cubic inches. So you will get about 25.6 square feet per 1/16 inch of thickness.
| Mixed Consistency | Putty |
| Mixing Ratio | 1 Part A to 1 Part B by Volume |
| Solids Content | 100%, by volume |
| Volatile organic Content (VOC) | -0- |
| Color | Grey (when mixed) |
| Weight per gallon | 8.5-9.0 pounds per gallon mixed |
| Pot Life | 5-7 minutes |
| Dry to Touch | 30-45 minutes |
| Re-Coat | 1-1.5 hours |
| Sanding Time | 2 hrs |
| Full Cure & Maximum Resistance | 5 days |
| Tensile Strength (ASTM D638) | 8,500 psi |
| Adhesion to Concrete (ACI Comm 403) | 350 psi (100% Concrete Failure) |
| Hardness (ASTM D-2240) | 80 (Shore D) |
| Flexural Strength (ASTM D-790) | 8,000 psi |
| Compressive Strength (AST D-695) | 11,000 psi |
| Service Temperature | 150°F (wet) 160°F (dry) |
| Water Absorption (ASTM D670-73) | 0.10% maximum |
Contact Epoxy.com Ordering Department at 321-206-1833
Epoxy Gel Super Fast Cure Product #2704 is typically installed as a base material beneath Epoxy.com Flooring Systems. However, if needed, Epoxy Gel Super Fast Cure Product #2704 is easily cleaned with neutral soaps or detergents. Routine mechanical scrubbing is recommended for all surfaces having a non-skid texture.
Epoxy.com provides services and consultations on material selection, specification, troubleshooting, and other information on the proper repair and protection of concrete surfaces. Epoxy.com Sales Representatives and Epoxy.com Technical Services are available to assist you. Call: 352-533-2167 or visit www.Epoxy.com.
You can find more information on Epoxy Gel Adhesive Products, and many of our other products at news.epoxy.com.