Epoxy.com Product #406 is a two component, chemical resistant, polyurethane coating. Epoxy.com Product #406 is a low VOC compliant urethane that meets all federal and state environmental air quality standards. The high gloss finish offers excellent abrasion resistance, chemical and stain resistance, and superior color retention. Epoxy.com Product #406 can be used equally well on vertical or horizontal surfaces. It is ideal for concrete floors and walls in warehouses, storage facilities, aircraft hangars, animal housing, and vehicle maintenance facilities. Available in both clear and pigmented formulations, Product#406 can be used as a finish coating option for most Epoxy.com Flooring Systems.
Two component, catalyzed, chemical resistant polyurethane.
Surface Preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Epoxy.com Surface Preparation Procedures. Work must be performed by trained or experienced contractors or maintenance personnel.
Epoxy.com Product #406 is normally applied with a brush, short napped roller, or squeegee and back-rolled with a short nap roller. Care should be taken to minimize the entrapment of air caused by over-rolling.
Epoxy.com Product #406 can also be applied by airless or conventional spray. May be thinned 9-10% with Ethyl Ethoxy Propanate (EEP) or Methy Amyl Ketone (MAK).
Clean skin with soap and water. Tools and equipment should be cleaned with xylene or lacquer thinner.
Epoxy.com Product #406 Clear will yield approximately 2.9 mils dry film thickness when spread at 300 ft2 per gallon.
Epoxy.com Product #406 Pigmented will yield approximately 3.5 mils dry film thickness when spread at 300 ft2 per gallon.
Epoxy.com Product #406 is available in Clear. Available pigmented with a minimum of 30 gallons. Custom Colors are available subject to laboratory approval, larger minimum quantity, lead time for production, and increased cost.
| Viscosity @ 75�F | 125-150 cps, mixed, Clear |
| Mixing Ratio | 3 Parts A to 1 Part B by Volume |
| Solids Content (by Volume) | 54.26% Clear 66.46% Pigmented |
| Volatile Organic Content (VOC) | 1.56#/gal (187 gm/L) Clear 1.39#/gal (166 gm/L) Pigmented |
| Weight per Gallon | 9.85 pounds per gallon , mixed, clear |
| Pot Life | 8 hours @ 75�F |
| Dry to Touch | 10-14 hours @ 75� |
| Re-Coat | 12-16 hours @ 75� |
| Light Service | 16 hours @ 75� |
| Full Cure & Maximum Resistance | 5-10 days |
Contact Epoxy.com
After completing the application of Epoxy.com Product #406, the installer should provide the owner with maintenance instructions.
Epoxy.com Product #406 is easily cleaned with neutral soaps or detergents.
Epoxy.com Technical Support provide services and consultations on material selection, specification, troubleshooting, and other information on the proper repair and protection of concrete surfaces.
R-Recommended for continuous service.
L-Limited Recommendation, occasional spills.
*-May cause slight stain or discoloration.
You can find more information on Polyurethane Products, and many of our other products at news.epoxy.com.